#Harbor breeze ceiling fan remote manual install#
#Harbor breeze ceiling fan remote manual code#

#Harbor breeze ceiling fan remote manual code#

This remote control unit is equipped with 16 code combinations.Store the transmitter away from excessive heat or humidity.(To prevent damage to transmitter, remove the battery if not used for a long time).

#Harbor breeze ceiling fan remote manual install#

Install 12 volt battery(not included).

Reinstall the canopy on the mounting bracket.

Lay the brown antenna wire on top of the receiver, and put the receiver into the mounting bracket.

Push all connected wires up into junction box.

If other fans or supply wires are different color, have this unit installed by qualified licensed electrician. Orange receiver wire(UP LIGHT).Orange light wire White receiver wire(TO MOTOR N).White fan wireīlack receiver wire(TO MOTOR L).Black fan wireīlue receiver wire(DOWN LIGHT).Blue light wire White receiver wire(AC IN N).White supply wire Use wire connecting nuts supplied with the fanįROM POWER SOURCE AC 110/120 VOLT 60Hz 3.5AMPS.īlack receiver wire(AC IN L).

FAN MUST KEEP AT THE HIGH SPEED POSITION.

LIGHT MUST KEEP AT THE TURN ON POSITION.

Make connections as follows, using the wire nuts:.

Disconnect existing wiring between ceiling fan and Supply in electrical junction box.

Remove ceiling fan canopy from the mounting bracket.

Otherwise power can cause serious injury or death. Maximum up light watts: 100 incandescent and ballast. Maximum fan motor amps: 1.0, Maximum down light watts: 240 incandescent and ballast. Supply for fan must be 110/120 volt, 60Hz. HIGH VOLTAGE! Disconnect power by removing fuse or switching off circuit breaker.Įlectrical wire must meet all local and national electrical code requirements. The receiver can remember the last codes status. Keep pressing the button learn key in excess of 3 second it becomes a LEARN status. If not, please press the Power button to restart. The Learn Key must be pressed within 30 seconds, after pressing the Power button. Use a Small screwdriver or ball point pen to slide firmly up or down (Figure 1)).

Slide code switches to your choice of up or down position.Press firmly on the arrow and slide battery cover off. To set the codes, perform the following steps: This unit has 16 different code combinations. INSTRUCTION OF INSTALLATION AND OPERATION SETTING THE CODES The red indicator on the transmitter will light when one of the five buttons is pressed. The light dimmer button will control the light brightness dimmer and off. There are four buttons (HI, MED, LOW, OFF) to control the speed of the fan and off. This remote controller is designed to separately control your ceiling fan speed and light brightness.